The SA series is the smallest metal carrier with a curve height of only 3.5 inches (89mm) and 1-inch link height.
How To Create A Part Number:
Model – Height – Length – Bracket (fixed) – Bracket (moving)
Example: SA-35-15.00-#1STD-#1STD
⇒ Length is specified in inches, to two decimals. It is the distance between flanges
⇒ (see formula on carrier side view diagram)
⇒ Specify bracket type and arrangement # for each end
Carrier Cross Sectional View
| Model | A (inside width) | C (outer width) | Weight (lb/ft) |
| SA | 0.94 | 1.29 | 0.70 |
Specifications are listed as inches unless otherwise noted
Carrier Side View
Travel/2 + CL (+ Offset Distance From Center*) = Length
Dynatect recommends mounting the stationary end of the carrier at the center of travel, minimizing the required length.
In cases where center mounting is not possible, add the distance offset from center to the carrier length calculation.
| Height | R (bend radius) | H (curve height) | K (depot) | CL (curve length) |
| 35 | 1.25 | 3.50 | 3.00 | 6.43 |
Specifications are listed as inches unless otherwise noted
How To Create A Part Number:
Model – Height – Length – Bracket (fixed) – Bracket (moving)
Example: SA-35-15.00-#STD#1-#STD#1
⇒ Length is specified in inches, to two decimals. It is the distance between flanges
⇒ (see formula on carrier side view diagram)
⇒ A standard bracket (STD) and arrangement # is specified for each end e.g. STD#1
Carrier Cross Sectional View
| Model No. | A (inside width) | C (outer width) | Weight (kg/m) |
| SA | 24 | 33 | 1.04 |
Specifications are listed as millimeters unless otherwise noted
Carrier Side View
Travel/2 + CL (+ Offset Distance From Center*) = Length
Dynatect recommends mounting the stationary end of the carrier at the center of travel, minimizing the required length.
In cases where center mounting is not possible, add the distance offset from center to the carrier length calculation.
| Height No. | R (bend radius) | H (curve height) | K (depot) | CL (curve length) |
| 35 | 32 | 89 | 76 | 163 |
Specifications are listed as millimeters unless otherwise noted
Specify bracket arrangement and direction of flange. Mounting holes can be inward facing or outward facing.
Example: #1 arrangement and inward facing holes = #1-IN
Example: #4 arrangement and outward facing holes = #4-OUT
Standard Mounting Bracket Arrangements
Bracket Mounting Hole Dimensions (Top View)
Specifications are listed as: inches (millimeters) unless otherwise noted
Weight Load:
Use our contact page to get in touch with us directly for placing an order, requesting a quote, or getting your products repaired.
Use Our Contact Form
